The Qlxhbot Magnetic Door Switch is a mechanical reed switch system housed in an ABS flame-retardant chassis. Hardware analysis confirms a purely analog operation with no internal chipset or firmware, resulting in near-zero hardware latency. The switching capacity is rated at a maximum of 100V DC and 0.5A, which is suitable for signal-level trigger loops in hardwired security architectures.
Structural dimensions and gap tolerances indicate a 15mm to 25mm threshold for loop state changes. Because the device is protocol-agnostic, it functions with any system accepting a dry contact input, including legacy alarm panels or modern microcontrollers. The mechanical nature of the glass reed switch requires protection from extreme physical shock to prevent internal component failure.
Aggregated technical data confirms the following:
- Power: Zero standby power consumption.
- Wiring: Compatible with Normally Open (NO) or Normally Closed (NC) configurations.
- Mounting: Support for adhesive foam or mechanical screw attachment.
Due to the lack of built-in encryption or wireless transmission, this hardware requires a physical cable run to a central interface. Integration with digital platforms necessitates the use of a logic board or external transmitter to convert the binary analog state into a network-accessible signal.
Implementing the Qlxhbot Magnetic Door Switch is recommended for permanent, battery-free installations where physical wiring is feasible. These components represent the fundamental mechanical standard for alarm system sensors in hardwired configurations.
